TiZip Masterseal 10 Drysuit Zipper
TiZip Masterseal Zipper
- Waterproof - Airtight - Pressure Tested
- Thermoplastic Polyurethane teeth, dock, puller
- Engineered in Germany
- Sealing strength up to 700 mbar
- Cross tension 200 N/cm
- Temperature parameter -30 degrees to 70+ Celcius
- Installation methods include HF welding, sewing and taping, or gluing
- Tape with 70 mm
- Tape end overhang 25 mm
- Chain width 10 mm
- Closed at both ends with one slider
- Suitable for both freshwater and saltwater applications
- Recommended for water sports, protective clothing, and outdoor gear
INSTALLATION
The zip must not be roughened for installation. The welding temperature, welding time, welding electrode and contact pressure must be optimally adjusted to the zipper (material, geometry, etc.). Tests are recommended before installation.
BEST PRACTICE
Operate the slide gently. Pulling at an angle can negatively affect the zippers, e.g. their tightness. Avoid overstretching the docking end and end pieces if necessary by using the optional Q-Strap*. Do not pull the two sides of the zipper apart forcefully. Be careful not to fold or squeeze the zippers. Close each zipper carefully so that the slider lies correctly in the docking end to guarantee tightness.
CLEANING
Dirt particles, especially between the teeth, can affect the sealing lip and thus negatively affect the tightness and durability. We recommend a light soapy water and a fine brush. Do not use solvents or aggressive cleaning agents as these negatively affect the function of the zipper.
LUBRICATION
MasterSeal zippers need to be lubricated from time to time. Apply gently the lubricating grease in the area of the docking end on the front and back, as well as on the inside at the transition to the zip chain. Do not use grease along the zipper chain. Remove remaining lubricating grease to avoid stains. Use the original TIZIP® lubricating grease or Food Grade silicone grease.
STORAGE
TIZIP® zippers should be stored completely closed, dry, clean and without bending.